Steps on How Do You Fix a Burnham Gas Boiler? Read And Know

When Burnham boilers aren’t working right, problems can happen that could damage the boiler or heating system. This can hurt not only the boiler but also the pipes, which could lead to damage from water. It pays to know how to figure out what’s wrong with your Burnham gas boiler because if you don’t keep it in good shape and check for problems right away, it could cost hundreds of dollars to fix. Keep on reading how to fix a broken Burnham gas boiler!!!

How Do You Fix Burham Gas Boiler

Step 1: Check The Float Switch:

If the float switch on the side of the boiler gets stuck, you can free it by giving it a good whack on the side. If it is stuck and you can shake it loose, the motor of the feed pump will start, and the water level meter will start to go up. If not, make sure the electric system is turned on, and the gas line is turned on.

Step 2: Remove Boiler Cover

With the screwdriver, remove or loosen the cover screws on the Burnham gas boiler and pull them up and out. This will take off the lid. Take off the cover and set it aside.

Step 3: Raise The Thermostat Temperature

Go back to the boiler and turn the thermostat all the way up. The flames should be going in the manifold, and the heat exchanger in the boiler should be getting hot. If this is the case, put the cover back on and set the thermostat to the right setting.

Step 4: Check the Wire connections

Check the wires on the thermostatic control board of the boiler. You can make sure the wires are connected right by gently pulling on them. If the screws on the temperature control board’s wires are loose, tighten them with a screwdriver.

Step 5: Evaluate Water Level

Find the water level gauge on the side of the gas boiler. The level on the gauge shows how much water is in the boiler. If the water level is too low, the boiler will shut down automatically, and even if the thermostat calls for heat, the boiler will not turn on. You can find the trip level in the manual for your Burnham tankless coils.

If you don’t have a guide, check the sight glass. If there is less than a quarter full of water, the level is too low. Press the relief valve on the top of the boiler to let water flow back into the boiler. Too much pressure can stop water from going back into the boiler to be heated up again. If the water level goes up in the boiler, it needs to be turned back on.

Reasons Why Not to Keep Boiler Off All Summer

You just read about what kind of boiler needs to be turned off in the summer. But you can turn it on every once in a while to keep the valves working. Also, if there is something wrong with the system, you will know about it right away, so you can fix it before it gets cold.

In The Bottom Line

You can fix the Burnham gas boiler by doing these things. Also, Burnham boilers do have a certain amount of time they can last. If you’ve had a house or business for a long time, you may need to replace it at some point. Getting it checked out and fixed will make it last longer. If you don’t take care of your boiler, it won’t last as long. This way, you won’t have to pay the higher costs of replacement.